LAMONA LAM1703 Manual de usuario descargar pdf (Pagina 10)

What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the hob.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connec-

tion diagram.

The fuse is blown. Make sure that the fuse is the

cause of the malfunction. If

the fuse is blown again and

again, contact a qualified

electrician.

Residual heat indicator does

not come on.

The zone is not hot because

it operated only for a short

time.

If the zone operated suffi-

ciently long to be hot, speak

to an Authorised Service

Centre.

If you cannot find a solution...

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass surface). Make sure, you operated the hob

correctly. If not the servicing by a service technician or dealer will not be free of charge,

also during the warranty period. The instructions about the Service Centre and conditions

of guarantee are in the guarantee booklet.

Installation

WARNING! Refer to Safety chapters.

Before the installation

Before you install the hob, write down the information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble the hob into correct built-in units and work

surfaces that align to the standards.

Connection cable

• For a single phase or two phase connection use the following (or higher) mains cable

type: H05V2V2-F T min 90°C.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

LAMONA LAM1703 Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Placas LAMONA LAM1703